Leica 301-360.040 Printed Circuit Board  

Product Manual：

Leica 301-360.040 Printed Circuit Board
Introduction: Leica 301-360.040 is the original control PCB board that comes with Leica precision microscopes
Original precision multi-layer circuit, stable signal transmission with low interference
Gold plating treatment on solder pads, wear-resistant and corrosion-resistant, stable contact
The substrate is resistant to temperature and vibration, suitable for long-term continuous operation in the laboratory
Built in grounding shielding layer to reduce electromagnetic signal interference
Line partition layout, separation of strong and weak electricity to avoid short circuits
Standard positioning aperture, can be directly replaced without the need for equipment modification
Reserved testing points for easy and efficient troubleshooting
Onboard filtering circuit ensures accurate microscopy imaging data

The silk screen components are clearly labeled and easy to disassemble and inspect
Compatible with Leica INS and ERGOPLAN series microscopy equipment
The board is dust-proof and moisture-proof, reducing laboratory dust damage to the circuit
Original factory aging testing with low operational failure rate
Multiple sets of standard plug-in interfaces to match the signal transmission of the entire machine
The impedance of the circuit is uniform, and there is no delay or offset in the control signal
Reinforced sheet structure, equipment vibration is less likely to cause welding and wire breakage
Conclusion: Leica 301-360.040 is compatible with Leica precision observation equipment, with strong compatibility and stable operation

Product detailed pictures：

301-360.040

product video

Other links

3BHB030310R0001 thyristor module
MOTOROLA MVME167-33B Single Board Embedded Controller
HONEYWELL SC-UCMX01 Analog Input/Output Module

Other links

GJR5252300R3101 07AC91H module
ILS1B853S1456 motor
KOLLMORGEN S20660-SRS Servo drive